I have a Pioneer VSX-33 A/V receiver that outputs HDMI to an Epson 8700UB projector (seen here). How do I know which component is doing the video processing? When my Blu-ray player or satellite receiver runs through the AVR and out to the Epson, does the AVR do all the processing, or does the Epson's video processor? I guess I would prefer to have the Pioneer do all the video processing since its Marvell Qdeo chipset has been so favorably rated.
If you haven't adjusted anything in the VSX-33's Video Parameter menu, it's doing the processing and sending a 1080p signal to the projector, which does virtually nothing to such a signal. To check, open the AVR's Video Parameter menu and make sure the V. Conv parameter is set to On, which is the default. (If it's off, the AVR is doing no video processing.)
Most Blu-ray discs are 1080p, so there's little if any processing to be performed in that case. Blu-ray movies are stored on the disc at 1080p/24fps, and the Epson 8700 can display this at 96Hz (each frame is displayed four times), which is smoother than displaying 24fps at 60Hz, so make sure the Epson's 4-4 Pulldown setting in the Signal menu is on, and set the Pioneer's Res control to Pure or 1080/24p.
Some Blu-rays store content at 1080i, and most HDTV from the satellite is 1080i, so these signals must be deinterlaced. You're right that the Marvell Qdeo chipset is excellent, so having the Pioneer do it should look great. To be sure which does a better job, look at some 1080i content with the AVR's V. Conv control turned on, then again with that control turned off.
If you have an A/V question, please send it to email@example.com.